FC Bucket Elevator Specifications
--------------------
En-Masse
Conveyors
--------------------
Hi-Flight
Conveyors
--------------------
Roller Belt
Conveyors
--------------------
Accessory
Equipment

Standard Buckets
Buckets are constructed of a durable non-sparking polyethylene. Optional steel, nylon or urethane buckets also available.

Other FC Bucket Elevator Options...

• 12 gauge trunk construction.

• 1/4" (6.35mm) expanded metal back urethane head housing and hood liners.

• Galvanized head service and distributor service platforms.

• Ladder and safety cage with rest platforms.

• Winged self cleaning boot pulley.

• Flared boot hopper.

• Standard boot hopper.

• Urethane lined head discharge transitions.

• Guy cable brackets.

• Factory assembled trunking.

Elevator Head features include...

• Two piece hood for interior accessibility.

• Full radius contoured hood to minimize wear and improve material discharge flow.

• Heavy duty crowned face double disc drum pulley with SOFR (static conductive, oil resistant and fire retardant) lagging.

• Weather tight internal lip seal between head housing and hood to eliminate moisture problems.

• Bearing plates with vertical jack bolts for final installation alignment.

• Fully adjustable throat plate.

FC Bucket Elevator Boots
Our elevator boots use a structural iron frame construction for solid support throughout the boot. All stiffeners and frames are powder coat finished before assembly for maximum corrosion resistance.

• Externally mounted pillow block bearings.

• Belt tension take-up screws utilizing corrosion resistant acme threaded rod.

• Machined, full length UHMW shaft seal at take-up plate bearing surface.

• Hinged boot inspection door on both sides.

• Heavy duty crown faced double disc drum pulley.

• Easy access cleanout doors on each end. Drop down design used on larger elevators.

• Removable panel at the top of the boot, between trunks, can be adapted to dust collection equipment.

• Standard boot construction of heavy gauge steel and bolted structural angle iron frame with vertical stiffeners.

Farm-Com Trunking

• 14 gauge steel bolted construction.

• Fixture welded, structural angle iron flanges are continuously welded on the outside and stitch welded on the inside.

• Maintenance friendly 10' (3048 mm) inspection section with 9' (2743.2 mm) long opening at both front and back. Front and back panels can be removed in 3' (914.4 mm) increments. The inspection door can be located in 6 different locations for ultimate flexibility.

• Unique bolted cross tie design provides rigidity, squareness to trunking and is independent of flange bolts.