Network Autoflow

Released 10/20/14

The Network Autoflow software now consists of 3 individual processor controls. Each of these computers must be updated with proper versions of software to insure compatibility.

NOTE: The IO and Heater software has been renamed to reflect which versions of the Display software this software will work on. ** Version 2.21 Autoflow Display software resolved an issue only if the software was configured to start drying when the High Level Chamber switch was active. It was reported that if this option was selected that sometimes during the dump cycle if the High Level switch became exposed from grain falling away then it may cause an issue with the dump chutes not closing after the dump cycle timer was completed.

Released 04/25/00

Software versions 105-216 have been updated to compliment the new R7 S2000 board redesign.

For systems running WatchDog only

For systems running WatchDog only